[Tfug] usb flash disc

[Christopher Mathis]

try /dev/sdc or sdb, the sda2 would be partition 2 of device 1 (or 0
depending on where you start from) sdb would be device 2 and sdc would
be device 3 and so on just like with ide where it comes in as hda hdb
hdc and so forth...

Chris

On Mon, 2003-11-10 at 01:37, jbrouse at cox.net wrote:
> I have tried to get my usb flash disc to work by making edits to /etc/fstab and the problem is that I have not been able to determine where usb-storage is loading the usb flash disc in. For example /dev/sda2 could be the usb flash drive but I recieve the following error: /dev/sda2 is not a valid block device  
> 
> 
>   When I cat /proc/scsi/scsi I have the below output:
>  cat /proc/scsi/scsi 
> Attached devices: 
> Host: scsi0 Channel: 00 Id: 03 Lun: 00
>   Vendor: PLEXTOR  Model: CD-ROM PX-40TS   Rev: 1.05
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi0 Channel: 00 Id: 04 Lun: 00
>   Vendor: PLEXTOR  Model: CD-R   PX-W1210S Rev: 1.05
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi2 Channel: 00 Id: 00 Lun: 00
>   Vendor: USB      Model: Flash Driver     Rev: 1.11
>   Type:   Direct-Access                    ANSI SCSI revision: 02
> 
> When I run the following command when plugging in the flash disc "tail -f /var/log/messages" I recieve the following:
> kernel: usb.c: USB disconnect on device 00:07.3-1 address 2
> kernel: hub.c: new USB device 00:07.3-1, assigned address 3
> 
> 
> 
> 
> Jim
> 
> _______________________________________________
> tfug mailing list
> tfug at tfug.org
> http://www.tfug.org/mailman/listinfo/tfug